Chosen Solution
I was cleaning out my ps4 pro to re apply the thermal paste and the psu connector I was trying to remove for the power supply ripped off because I wiggled it too hard. Now I was just wondering if I can solder it back on in the condition is in right now. Have been looking for a similar question everywhere but can’t find one for a pro, thanks in advance!
Hello everyone, I’ve fixed a same Issue on the PS4 Pro, but with some pads ripped off. I did some measurements on the board and would like to present you some information. The bottom right pad ripped off and to Murphys Law, there was only a tiny bit of that via left, but there was hope, due to the fact, that there is a corresponding pad on the other side of the PCB. The RED-Dot on the picture shows the corresponding pad, for that exact pin. All that is left to do, is soldering a wire from that pad to the pin on the connector. I added a picture of my solution. Perhaps it’ll help someone.
back of the PCB, red dot marks the pad.
screw hole sacrificed as via.
Joel Reyes the solder pads look ok but not sure about the connector. For as long as your metal sticking out past the plastic you should be good soldering it back on. Make sure that you do have the experience and tools to solder on the circuit board. https://www.youtube.com/watch?v=1a-U2NNd…
Hey bro i had the same problem if was really hard to disconnect my power supply all the videos i watched for them it was really easy and quick to disconnect but not mine,but them it can out with connector and all ☹idk if it can be fixed i didnt find any video of page about this problem hope u have new info and can help each other
