Chosen Solution Can anyone help me in solving issue of Print Spooler Service is Missing. Print Spooler Service is Missing or not listed. Need permanent solution. Are you using it for first time? Yes, I am using it for the first time. I rebooted but still facing same problem.
Chosen Solution I bought a Promark P70 Drone from a family member and gave it a “test run” doing flips, flying it far away/up close, up/down, landing, lights worked perfect, etc. As matter of fact their son (my cousin) had only used it a few times. When I got home I flew it until the battery needed charged. After I plugged it up to charge it (I sadly used a charging cord that did not come with it), there was a loud “pop” noise and I haven’t been able to use it again ever since....
Chosen Solution Here are the symptoms My og PS1 and og PS2 do not work in game but they do work in the system menu in port 2. Both analog lights come on at all times My 3rd party controller works at all times however the sticks and buttons feel so terrible to play with that I cannot bear to use it. The only things I can think to do would be buying a new controller or changing out the controller port in the system, however I do not want to do anything unless I’m sure It will solve my problem....
Chosen Solution I have a release PS3 that was clumsily dropped about a foot off the ground. There was no external damage, though when I plug it into a TV it will not work. Here is a list of things I have done: I have held the power button to reset the graphics card to use the AV video cables.I have inspected all ports and used known good TV’s and Cables....
Chosen Solution Hi have this redmi 4a ..it just automatic restarting again and again until it get 0℅ battery .but when i plug the charger .it backs to normal while the charger is being connected ,but if i unplugged it ,it back to restarting again ,after that it shutdown and never turn on back ….What Should i do ? Should i buy a new Battery? Please help me Board heating and and phone on and off ....
Chosen Solution I just found my old Shuffle 4th Gen yesterday and charged it this morning. Earlier I took it off the charger and tried to use it. It works fine, except for the fact that it makes that sound all iPhones make when you lock it. I have to turn it off and back on to change the song, but as soon as I skip to the next song it locks again and won’t let me change the song or the volume....
Chosen Solution My toro grandstand Kawasaki engine is having hard time cranking over. But the starter and battery is good. I took out the plugs and it turns over fine. What could be the issue? The engine model is a Fx730v I replaced the stater magnets and flywheel, it has been having trouble with the battery not charging and kept dying. I checked the coils twice to make sure they weren’t touching and everything...
Chosen Solution Kenmore front loader won’t complete a cycle. ThePF code appears and can’t be reset. I tried all the suggested fixes, none of them worked. PF is power failure error meaning electricity has been interrupted to the machine. An electrical interruption of any type can cause a PF error code. Try this: Press the Pause/Cancel/Stop button twice to clear the PF in the display.
Chosen Solution My duplex fridge was set at -4 F on the freezer and 40 F on the fridge side, it feels cold but ice cream is softer than it should be and ice in the ice bucket stuck together from melting a little so I guess is not freezing correctly. I set it up at -6 F and now it is freezing fine but I know the temperature is set too cold!...
Chosen Solution Hi, I’m hoping someone can assist me here, I failed miserably at transferring over my previous chats from my s9 to my s10+ via for GBWhatsApp . I admittedly was messing with the folder structure on the phone and made some obvious mistakes. GBwhatsapp will load now however I can’t initiate a new message (it just brings me right back to the initial screen) what’s app web won’t work either....
Chosen Solution Hello, I have the following problem. My Nintendo Switch boots only up to the Nintendo bootscreen and then goes out immediately. Sometimes I come up to the start screen, but after a few seconds, the console switches off by itself. I removed the back panel and found that the fan was not spinning. Does anyone have an idea what I could do? Greeting T. There is a chance that the console has frozen with a black screen....
Chosen Solution no incomming call music or noise My phone did that and I found the volume setting in the control panel had 4 different volume settings ringer, alarm, notifications and music. The ringer volume was set to 0.
Chosen Solution Replaced a old weak or wimpy horn on my van that has a viper alarm system installed. After replacing horn and verify it worked, the alarm all worked except that there is no sound coming off the new horn from alarm. Lights flash, car lockes, remote start work. But alarm which only sounds on my fob, will make no sound in my van. I suspect and hope its a fuse, but it’s so disorganized under that dash…I need help please....
Chosen Solution While I was using my mac, it shut down suddenly and since then I am unable to turn it on. When I pressed the power key the only thing I can hear is both fan running at full speed. Even if I open the lid (without pressing the power key) the fan starts running at full speed with no sign of powering on. What might be the possible solution?...
Chosen Solution I spilled soup on my MacBook pro. I immediately turned it off. I then removed the logic board and cleaned it with a toothbrush and isopropyl alcohol. Now it’s not even turning on. Is there anything I can do to fix this without paying through the nose? Ensure logic board is completely dried up. Use hair blower with low temp setting if needed. If above did not work, buy a keyboard replacement and see if it can trigger the power....
Chosen Solution How many ram slots is inside of this laptop? And what is the maximum gb of ram? 2 DDR3L ram slots, max size 8 Gb total (8Gbx1 or 4Gbx2). Check out owner’s manual for more specs
Chosen Solution I have a HP Zbook 17 mobile workstation .this laptop can’t detect Nvidia driver whereas in the previous widows 7 works perfectly .i tried so much to work on this windows but it can’t detect .just working on original intel graphic although Nvidia installed but it is not working . please help! Hi, Since we don’t know what you’ve tried: Is the Nvidia graphics adapter shown listed in Device Manager > Display Adapters or perhaps “Other Devices”?...
Chosen Solution I have an xserve 2006 (emc2107) running MacOSX 10.7.2 Lion Server. I read that it can be upgraded to 10.7.5. I burned a copy of 10.7.5 client upgrade and 10.7.5 server upgrade. Here is the good part, I mislabled the disks. So I used 10.7.5 client upgrade on the xserve running 10.7.2 Server. Is there a way to recover my server os? I hope that just installing the 10....
Chosen Solution Hi, My Panasonic th-p58v10a plasma TV has 8 red blinks. I believe it may be the SS board that is faulty. Does anyone know the part number for this board or other items that may be faulty? @broso 8 blinks means there is a power issue or possibly a bad connection on/to the power board. Could you take the back off the TV and then take the power board out of the back to take close up and high resolution pictures and upload to your question following this guide Adding images to existing questions My first step would be to unplug the power board and then reseat the connection, making absolutely sure the connections are fully seated correctly....
Chosen Solution Printer started blinking with red light on ink and paper indicator as well as on the wifi indicator too while i was scanning a document. Ink and paper is available in my printer its sensor problem i have the same problem last two days. you have to call an engineer. you have to open the scanner glass and clean the sensor.
