Chosen Solution I own a copy of Pokémon Gold that doesn’t boot. It gets stuck at the Game Boy screen with a scrambled Nintendo logo. I’ve re-soldered every chip on the board with flux yet nothing seems to fix it. Are one of the chips dead? Is there anything I can do? Thank you for any help :) Sounds like dirty contact points to me. If other carts play fine, likely not the device....
Chosen Solution Hi Guys, My iPhone 6 refused to charge yesterday and so i brought it to a Service Center (because no apple care) and they said it was a problem with the Power IC and that they couldn’t fix it because they didn’t have the parts. So I am planning on buying a new 6S today to replace my phone but my problem is i haven’t backed up my phone recently (October was the last backup, stupid I know) and my computers wont even recognize the phone....
Chosen Solution ps4 blod turns on but only beeps once doesn’t show on tv and has no safet mode as it only beeps once no matter how long I hold it any ideas? Either power supply needs replacement or the APU (main processing chip) needs to be reflowed (or reball?) in order to get it working again.
Chosen Solution Hello, I have a problem with a ps4, basically this was working perfectly until from one moment to the next it turned off, I removed the power supply and found that it did not work, apparently it was damaged, so to verify that it was only the power source connect the ps4 to an external computer power source of 500w, when trying to turn on the console this makes the typical start sound, turns on the blue light, lasts a couple of seconds and shortly after turns off, during the first attempts to turn it on the ps4 fan began to rotate, but now it does not either, any idea of where the failure could be?...
Chosen Solution My PlayStation controller screw got stripped and can’t remove the screws how can I fix this ? i have a stripped screw on my controller @kevinlynch …here are a few tips to help remove the stripped screw. remember to not reinstall this screw after getting it out. also, if this was caused by not having the proper tool, please consider purchasing . How to Remove a Stripped Screw
Chosen Solution I just bought a rice cooker recently. It’s a philips HD-3017. I’ve never used a rice cooker before so I accidently took the pot out and forgot about it and well….I poured the rice and the hot water straight into the inner part of the rice cooker. I didn’t realize what I had done until I found that the water which I poured came out of the rice cooker from its sides its kinda like…....
Chosen Solution I have looked through many websites about how to fix these but the problem is non of them work. They all say things such as hold down - Power Button + Home Button + Volume Down Button - but none of these work. I have tried many things and this has happened before but I cannot remember how to fix it. I need to fix my phone because I would not have enough money to buy a new phone....
Chosen Solution my touchpad on my computer is not working……………………………………………. Take off the keyboard and there is a smaller cable in the middle holding the keyboard on. if it is disconnected, then there’s your problem. If it’s connected, try removing and reinserting it back into the slot. If that does not work, you’ll need to get a replacement keyboard.
Chosen Solution I have an XD card from my old camera and it won’t fit? Can I get an adapter or make this fit? The following memory cards are supported by Samsung. SD card (2 GB guaranteed), SDHC card (up to 32 GB guaranteed), SDXC card (up to 64 GB guaranteed) Class 6 and above recommended
Chosen Solution My Shield TV is bricked, and I believe the only way to fix it is to desolder the eMMC chip, reflash it with a correct image (and possibly replace it with a high-capacity chip) and resolder it to the board. The chip is a Sandisk SDIN9DW4-16G and it’s surface mounted so the solder bumps are under the chip. I have neither the skills nor the tools to fix this, so I need to find someone to do it for me but I have no idea where to look....
Chosen Solution I just installed the battery I got from Ifixit but the battery is not detected. Is it a “BIOS not detecting the battery” issue? Is the battery searching for a Razer Blade 2013 model BIOS? The battery is not charging and doesn’t hold a charge. The battery initially discharged for about 2 hours but after that it is not charging. One of the other batteries I purchased had the same issue....
Chosen Solution I had to replace the lightning port of an iPhone 8 a few months ago. Everything worked fine until the owner dropped it last week. There is no physical damage on the phone itself and I checked and reconnected the cable leading to the microphones. No sound is coming from the mic, except for a click every 3 or so seconds. Is there anything I could do before replacing the part?...
Chosen Solution Nintendo switch charges fine, but when put on the dock it will not work on the TV. It comes on for a second and its blury This is sometimes caused by the HDMI video chip P13USB on the back of the board. It can also be one of the filters below that chip be sure to check them for continuity from top to bottom first. In some cases a pad under the P13USB chip can become damaged....
Chosen Solution I had this issue a few years ago. I was at school with my dell latitude E6430 and plugged in my charger to charge, then it started to not charge at all. I though this would go away, but unfortunately it didn’t. It still have the same issue, whenever i plugged in to charge at home, it didn’t charge but only said it was plugged in. I tried contacting Dell support and Microsoft for help and solution and they couldn’t find the solution at all....
Chosen Solution i have desktop with two screens in a extend mode. one screen work just fine while the other . the primary screen turn off after about 4 hours. the pc is on high performance power plane . sleep mode and screen turn of set to never according to the plane. even in the domain group i put this pc in the group that design to never shutdown the pc in the group....
Chosen Solution My Dell laptop has been overheating when watching Netflix. After about 5 minutes of watching, the fan begins to ramp up, and after 10, it goes to full. I suspect either the RAM or the Intel 945GM graphics chipset. I have upgraded the CPU to core 2 duo T7600, and the RAM to 2x2 A-TECH PC-6400 RAM. HWmonitor does not display any abnormal tempatures, but when I touch the RAM it feels quite hot (around 50° c), but still not out of normal threshold....
Chosen Solution Greetings, I have a 2008 Honda Civic LX. My passenger side window would intermittently stop working. Than occasionally it would stop working and go up and down. When this happens neither the drivers side or passenger side switch will operate it. Now it wont do either and is stuck half way down. What do you think is the problem? Ive read many conflict reviews from the Main switch located in the drivers side switch control or the motor/ regulator?...
Chosen Solution So let me explain the title. I have an iPhone 7 plus that had a bad screen when I got it. I replaced it with a cheap screen off amazon, and it worked for the first part, until I fully put it into the device. After that, the screen stopped showing. The home button would still work (doesnt when phone is off). I tried a new screen but the same stuff happens....
Chosen Solution hi I have a blackberry z 10 every time I turn my phone on then it goes to the setup field but the last step where you have to connect a network it stuck every time and I have wireless connection at home , it says connected to the connection but then does not wants to move past that stage . what do I do now. I need help...
Chosen Solution Why won’t my platen roller turn in the Zebra ZM400 There can be a number of reasons for this, but first some questions: Can you hear a motor running when you expect the platen to be moving? Are the labels loaded properly without any labels stuck to the platen inside? Dan Great post Congratulations! Very enlightening! Ribbon Zebra
