Chosen Solution I just ran into an issue with starting my 5500. I have the parking brake on, etc. When I put my combo in to start mower, I’m not getting a green light to start. It’s just flashing red. It worked fine when I unloaded it after mowing most of the day yesterday. I went to load it up today and now it won’t start. Anyone have any ideas, suggestions would be greatly appreciated....
Chosen Solution the tablet was dropped and on off switch broke off. Needs to be more specific. Was the ribbon cable or the ribbon connectior broken. If possible show an image of what it looks like. Either it is a loose ribbon cable or a broken connector.
Chosen Solution After doing a battery replacement I noticed that the phone shutsdown when the battery still had charge (according to the battery icon that is). I drained and fully charged a few times and even left it on the charger overnight but still have the issue. Anyone else having this issue? It is better to do a factory reset after battery replacement. The ‘software’ perhaps is still using ‘calibration’ from old battery....
Chosen Solution I have a Samsung un32j4000bf I can turn it on by doing a power cycle. Once its turned off then it will not turn back on unless I power cycle it again. I have tried to turn it on via the remote and the power button on the tv. Still nothing, the standby light does not flash or anything, Just stays solid. Front of the power button board, It does have continuity when the button is pressed....
Chosen Solution oxygen sensor not communicating code p140 Thoroughly examine the wiring harness to the oxygen sensor connector and then the wires to the sensor for cuts, breaks, abrasions, rubbing, etc. and fix where appropriate. Also examine inside the oxygen sensor connector to make sure the pins are there and are not dirty/corroded. If this does not fix the engine code or there are no issues with the wire harness, I would replace the oxygen sensor....
Chosen Solution Hi Fairphone/Ifixit, During the repair of my Phone I was tapping it on the table to get some dust out, it came out, but also a smal plastic ring, about 3 millimeter in diameter and 2 millimeter high. It was also more narrow on one side as the other. I couldn’t find out where it came from, so I put back together the Phone and it seems to be working fine....
Chosen Solution This is an old phone which I’d received from my previous employer so as to manage their social media channels.It was able to hold it’s might through numerous drops and screen damage (with subsequent replacements). It has finally given up and is now completely dead. My attempts at superficial repair has proven that the problem is rooted deeper. I tried getting it fixed at a local repair shop but he gave up on the basis that parts aren’t available and that the motherboard has gone kaput....
Chosen Solution The phone is not charging. I then fitted a new battery which showed 100% right up until the battery was exhausted. Can anyone tell me whether this is down to a part that can be changed or is this controlled by the logic board? Sounds like there may be a fault with your gas gauge, To check. Download a piece of software for your computer called “I backupbot” With it open and your phone plugged into your computer click on your phone, then click more information....
Chosen Solution Hello, my blackberry bold 9700 is having problems. Last night I had my phone next to me, next thing i know i heard the camera taking photos I picked it up and it would not let me get out of the camera so i took the battery out a number of times and also my sim card and I turned it back on. Then I can not click on anything my touch button in the midle of my phone that makes me click on things will not click - it moves from left to right but wenI go to click on anything it will not let me....
Chosen Solution When installing window I get the following warning. Stating that window couldn’t be installed on this drive. Please select another disk if available. This disk may fail soon. The S.M.A.R.T. reporting on the hard drive is reporting that the drive is failing. I would not install Windows on that drive. Will need replacing. Bill
Chosen Solution Hello just wondering if anyone can help I’m unsure if this is damage from damp in the conservatory or another issue with the screen? Any help advice greatly appreciated 😃 @melanieg it does look like issues with the LCD driver boards. Those are the boards that are on the bottom of the LCD panel and are connected with very thin ribbon cables. Those can corrode and lose contact. You can take your TV apart right down to the panel, check those ribbon cables and the boards....
Chosen Solution Hello all. I have an iPad Mini 3. I recently replaced the touch screen because it was cracked and now the Mini doesn’t lock or wake with the top power button, however it works when holding it to shut the Mini down. Unlike the Mini 4 and newer, the 3 doesn’t have a sleep/wake sensor that needs to be transferred over from the original screen. Thinking it could have been the aftermarket digitizer, I tired disconnecting the home button and digitizer at the same time, then just the digitizer but got no change with the power button....
Chosen Solution My Epson WF-7510 has suddenly decided it doesn’t want to feed single sheets of paper. I’m using regular printer paper, nothing fancy, that I’ve printed on for years with no problem. But now it grabs 2-4 sheets at one time, every time. I looked at the Maintenance menu on the printer but it doesn’t have an option to clean the rollers or anything involving the feed. (I read to do that on a different website, but it was about a different printer model that has those options....
Chosen Solution Hey Guys, Anyone else having issues with the durability of the Google Pixel 2 XL screen? I had mine in an otter box, with a screen protector on, in it’s OWN pocket of a purse (an isolated leather pocket on the front of the purse, meaning there was a layer of leather between it and my wallet and sunglasses case inside the purse. No keys or anything else in the purse....
Chosen Solution So just over a month ago i pulled apart my playstation to clean it i then proceeded to put everything back as it was and it wasn’t working (my step father pulled the little plug thing off the mother board but we got it soldered back on) and i tested it once we had the little thingy back on and my playstation beeped once and the blue light came on for exactly 2 seconds and turned off, i have since then bought a replacement power supply and that still hasn’t worked i have not replaced the factory thermal paste but the playstation was fine the day i decided to clean it so if anyone has any idea’s how to fix this please contact me...
Chosen Solution My ps4 pro was working perfect earlier today, i stopped playing for atleast 6 hours(it was off the entire time) i go to boot it up and nothing happens at all. i tried multiple outlets and it still didn’t work. hopefully its just a power supply its a easy fix and cheap. I would start there,
Chosen Solution I must have changed a setting on my camera without meaning to. Because now all of my pictures, if they are more than 5 feet from the camera, are coming out dark and really pixels. Help!!! http://cdn-10.nikon-cdn.com/pdf/manuals/… Look at page 38 for the “Two Button Reset”. It will restore your camera to default settings. That should reverse your accidental setting change. Hope this helps.
Chosen Solution A few days ago my power supply (EVGA 750 BQ 750 Watt 80 Plus Bronze) started making a sound that can best be described as a space ship accelerating. It happens every 5-10 seconds or so, and is relatively quiet. The odd thing is that the noise stops when under load. The sound is a faint rrrrrrrrrrrrRRRRRRRRRR in an exponential trend line, then stops, then does the same sound again a few moments later....
Chosen Solution My 40” RCA LED TV has no power or led lights lit. I tried unplugging, holding on the power button for 1 minute, waiting 10 minutes and then nothing. I do hear a clicking sound at regular 3 to 5 second intervals when I plugged it back in but nothing else. Here’s internal photos, what should I try next? Hi, Have you got a DMM (digital multimeter) and know how to use it?...
Chosen Solution my xiaomi redmi note 2 the screen is cracked so is doing ghost touch which mean it control it self just keep clicking anything @mofokeng as you already identified, your broken screen is responsible for the “ghost touch”. Replacing the screen will fix this issue. This video should help you with that. Nigga You are &&^&@@. Get it fixed before it develops its own brain and destroy mine oppo neo 7 screen is broken and still ghost touch is there...
