Chosen Solution I washed my phone with a baby wipe. it was already smashed at the back and a lil at the front. Later on , purple blotches began to show and is now getting worse. Anyway I could resolve this issue? kelseydixon9 that sounds very much like a broken display assembly. Post some images of what your screen shows with your question. That way we can see what you see....
Chosen Solution Hi, i have an interesting problem with my iPhone 6, After a screen replacement I was locked out and needed to reset the phone. The phone does in recovery mode connect fine to iTunes both on windows and macOS, however, after the recovery has finished and the phone has rebooted, it is no longer recognized by the computers. In macOS it does not show in the device tree and in windows it is recognized as a “eXtensible Host controller”....
Chosen Solution The button to turn on my phone has stopped working (right hand side at the top). Phone is fully charged but will not turn on. Hi, Try a power refresh and check if that resolves the problem. Remove the battery from the phone and then press and hold the Power On button for a full 30 seconds and then release it.Reinsert the battery and then try pressing the Power button and check if it turns on....
Chosen Solution My phone won’t charge unless I wrap the charger cable tightly around my phone. I can’t put my charger in normally. @matt100121 check your charging cord and see if the connector is bent or has some loose contacts etc. try a different charging cable. If the cable is good then the issue is with the charging port of your phone. You may need to change it by soldering a new connector to the board....
Chosen Solution hello, after a screen replacement with a refurbished one, now i have poor wifi and bluetooth signal on my lg g5. i suspect an antenna issue. someone know what could be the matter? yup sounds like the antenna. order a replacement and swap it over.. if this doesn’t fix it, will most likely be a logic board issue. 90% of all cases on the device is the antenna. furthermore make sure you reseat the antenna connection....
Chosen Solution Hi Community, I am wondering if its possible to customise firmware to remove the baseband installation process. I currently have an iphone 7 which is just going to end up becoming a data recovery due to GOD knows what the last repair shop did. However, i can nearly install firmware up until the dreaded 80% install, -1 baseband error (using 3U with data being saved option ticked) I have done all repairs around this error and cant invest anymore time on the project, but just wondered if this is at all possible?...
Chosen Solution I have an iPhone 7+ that out of no where stopped charging. By the time I realized it, it was down to 8%. Once the battery drained, it would show me the battery symbol and cord image instructing me to plug it in. When I would do that nothing happens. Is it charging port or software? It could be a bad battery, a bad charging port or a bad tristar ic control chip....
Chosen Solution Hello, I have recently picked up the tools to do electronics repair and my friend gave me his old fat PS2 that stopped reading discs. It was ejecting and then the tray would go back automatically when he showed me, but when he showed me he also jammed the tray shut after turning the console off and when I tested it later, the tray doesn’t even move any more :( The laser doesn’t appear to be turning on but the assembly still moves, though it seems to crash into the spindle and tick a few times before actually stopping....
Chosen Solution Hi everyone, I need your help to diagnose my PS4 problem. I can’t turn it on, dispite the blue light being on. Neither the touch power button, nor the Dualshock is working to turn it on. When i unplug the power cable, the blue light turns off, and when i plug it back, the blue light comes back and the PS4 beeps 3 times, but nothing on the screen, i can’t get it turned on or remove my bluray....
Chosen Solution Hello I changed the screen with the body to my pixel 4 because the original screen broke. After I fixed that the phone won’t connect to wifi. I noticed the the coaxial cable on the phone was damaged so I bought galaxy s8 cable from ifixit, because they didn’t have pixel 4 cable. I replaced it but the problem remained the same. I did all the troubleshooting steps online and still didn’t fix the problem....
Chosen Solution I have an Selphy CP760 and it continually says that I am out of ink even though I have replaced it 2 times. Since there is not any answers on this forum yet, I decided to answer it since I found the problem. The problem with this error is that the gear which runs the ink cartridge is missing? I took this device completely aprt and did not find any evidence of that gear anywhere....
Chosen Solution I would unplug everything plug it back turn it on to safe mode and it still does not show a display I’ve tried some other stuff and I’m very stuck any ideas? Always start with the easiest repair first. Try another HDMI cord. Plug in into a different HDMI port on the TV, Check the TV settings and make sure the HDMI ports are active (I can rename the ports to what I have connected to them i....
Chosen Solution My Kenmore Elite 795.73167.610 refrigerator (temp set to 36) and freezer (temp set to -1) last week freezer started to unthaw and then my fridge temp started to go up to 50 so I pulled all food out. The following morning the temp was fairly close to set temp and the only thing we did was wipe off the coils and turn off the ice maker. I turned the ice maker back on the next day and it sent my fridge temp back up to the 50s again (put a thermometer inside the fridge)....
Chosen Solution My screen has a blue tint when its suppose to be white. When its supose to be black, i have red beams shooting all over it. I did tpdrop it about a minth ago but i didnt have thus prob until last night. Please help, my mom is gonna be super mad. SOS :( I have a problem with my tablet when I was watching something on my tablet it keeps on glitching, like it was freezing, and I also my tablet is so unresponsive, it keeps freezing up and even though I try to speed up my Galaxy Tab 3....
Chosen Solution Got codesP0102 P0705 P0708 P1518 P1151 P1131 Where should I begin?I’ve changed all plugs, cables,cleanened egr valve, and iac+outerside of throttle body(in front of flap)z (was told not to touch on inside of flap since it has a lubricant that cannot be removed?). I also sprayed the maf with maf sensor cleaner a few times and did not touch fibers on inside cause Ive also been told not to touch them since they are fragile few times....
Chosen Solution I need to replace the gyroscpope on my Swagtron T1 but cannot find anywhere to buy the replacement part. Can someone please help me out and steer me in the right direction? I think should contact swagtron’s official site. they may help you..
Chosen Solution Our guys keep breaking indestructible phones. ;) It’s upwards of $240 to get replaced at depot. Has anyone ever replaced the display glass on a Sonim XP7700? If so, where did you get the display glass from? The phone is IP67 rated, and I haven’t done a screen on a phone with that rating. Are there special procedures? Do I need a qualification to do it and retain the IP67 rating?...
Chosen Solution My battery came to an end after 5 years almost so I bought a new one on ebay from a good seller. I’ve put it on charge and it charged fine after an hour perhaps. And when I tried booting it, the mac doesn’t respond. When I touch the button on the side all green lights apear, so the battery is ok I guess. I tried resetting the SMC, didn’t work eitheri tried ctrl command and power button, didn’t work either....
Chosen Solution Hi everybody I have a Macbook Pro 13 2015 (A1502). It was working fine, but suddenly it shut down and is not turning on anymore. Sometimes the fan turn on (trackpad also clicks), full speed. I tried to leave it with the fan running for more than 30 minutes, I press the power button for a while to shut the fan down and press it to turn it on but nothing happens....
Chosen Solution Hi, so I had this iPhone 6s laying around, completely dead. Replaced the charging port on it and the battery, then it turned on. Let it charge, used it for a bit, but noticed it got quite hot around the camera, so I turned it off for the night. Now the next day when I try to turn it on, it’s completely dead yet again, Power + Home Button does nothing, computer doesn’t see it....
