Posts

Chosen Solution I dropped it at my school and was fine until I got home. I dropped it 5 times on a road and sidewalk. What happen this time? @kayanna based on this " dropped it 5 times " it is most likely a broken LCD. Of course it is possible that it is a broken/dislodged display cable but unless you disassemble it, it will be hard to say. Let us know what exact model your Galaxy is and post some pictures of what your screen shows with your question....

Chosen Solution I have difficulty connecting the tablet to the charger. Even when I insert the charging cable into the port, the tablet does not charge. Check if the charger is connected firmly into the device. If the male tip of the charger is broken or crooked, then buy a new charger. The female port could be contaminated with particles, then clean out port gently using spudger If still does not work, seek professional help....

Chosen Solution I have Dell 5578 laptop and just getting slow so want to add speed for which I did see space for m.2 connector can be soldered on motherboard. So please help for you valuable suggestion if we can do it and will it be helpfull and workable. Regards Amit B Hi If there Isn’t a connector there it’s probably won’t work as it may need extra components on the motherboard in order for it to work Theres a chance it would work though but I would try it at your own risk However if it’s a SSD you are after you should able to use a SATA one if you have a port for it Hopefully this helps Thanks:-)

Chosen Solution I have a Dell Latitude D510 and have a new power cord cause it burnt up the the battery started to stop charging unless you wiggled the cord at the power jack and then one day is quit so did some research and found that the power jacks go bad but i have no idea how to take it apart and dont wanna break it thanks You can access service manuals for all Dell laptops at Laptop Manuals Hub Find your manual and follow the motherboard removal instructions....

Chosen Solution Hello, I just replaced my iPhone 8 battery using the iFixit repair procedure for the iPhone 8. I have done this procedure once before on this same S/N phone a couple years ago with no issues. Symptom: Once the new battery is installed the phone reports a 1% charge level on the battery. When plugging he phone in using an Apple OEM iPad charger (USB-A) and an Apple OEM charge cable (USB-A to lightning) the phone gives me the vibration indicating it’s detected the cable but no charging occurs (no lightning bolt in the battery icon)....

Chosen Solution Hi Guys thank you for your time, and thank you for your help I’ve been in trouble with my old (early 2008 iMac ) The problem was it was starting correctly but after it, I can’t do anything, like open an app or use the utilities, open a files…. Just the rainbow circle been loading for ages So I can just turn it off manually I’ve been trying all the reset PRAM , S , C and after discuss with you on ifixit, the best solution was to change the hard drive So now I have a new one , but after the installation with the 2 disc....

Chosen Solution I get an intermittent power light on and off every 20 seconds but only when connected to charger. Otherwise they will not even turn on if not connected to power. These earphones are two weeks old. Two weeks old and in need of repair? Just return them. If you try to repair them yourself, you void any warranty. If you fail in the repair, you have a pile of junk....

Chosen Solution Hi All, Just installed a new iFixit battery into my Mid-2012 15” Unibody MBP. Also replaced the DC in board and a new Apple 85W MagSafe charger. The battery is recognised and seems to work fine. However, when running on battery power the battery percentage drops down to around 50% after an hour or so and then all of a sudden it will drop from 50% down to 7% instantly....

Chosen Solution I changed the screen to Huawei Y6 it goes on but doesn’t read my touch. It could be due to a few factors. The connection from the new screen to the board may not be fully connected. Maybe you need to press it in a bit more, until you hear a click or snap sound. Don’t force it, but try that first.Either the board port for the screen or the screen connector could be damaged....

Chosen Solution Hello, I just purchased a new ssd transcend 850, after installing can’t see the ssd no where. I can’t see “views” in disk utility, cannot select “show every partition” . What can’t I do ? hola, se que es tarde, pero si alguién tiene el mismo problema dejo, la solucion: No reinicien el computador con las teclas command R!!. Deben encender el computador con la tecla option (alt). este iniciará el computador con el último sistema operativo que instalaron, en mi caso era el High Sierra....

Chosen Solution Purchase new nintendo 2ds. Unlocked write protection on SD card. Trying SD card in another system. New 2ds says write protection in enabled. Why is it not working? Have you tried to reformat the card on the other device?

Chosen Solution My car can start n rev up normally. But when I put in reverse or drive, it will not move. It suddenly lost drive after reversing it from the parking lot. Please help!! Have you checked the transmission fluid? Hi Kimpton… I have the exact problem with my Serena. How was yours resolved?

Chosen Solution Recently my cell signal on my OnePlus One has been getting worse and worse and finally today I cannot get any. No Service is all it says. I have tried.. -Toggling Airplane Mode -Switching Sim Cards -Installing Oxygen OS FRESH as well as CM12 FRESH -Wiped Cache Nothing seems to work so I am certain it is hardware. Does anyone know how to test the antenna hardware or where to obtain a replacement attenna?...

Chosen Solution I have recently been given an old macbook, 2008, running a A1181 logic board. when powered on , white light lights up, but often goes out after 10 seconds, repower up and it stays on, no boot chime and just a faint flicker on the screen, then all black, shining light from front or rear does not bring up display. i have checked all board connections, and SEEM ok, usb ports are working {at least to charge phone}, optical disc drive will not accept cd/dvd, discs just hang out about 1/4”, {i don,t think there is a disc in there already}, I intend to get a mini dvi to dvi adapter later today and try an external display....

Chosen Solution My LG47LA20V is getting sound but no picture, when I turn the tv on I get the LG logo for a split second then the screen is black but you can faintly make out the picture when you go up close. When I turn the tv off you see the full bright picture for a split second also. I’ve read this could be a backlight issue. If it’s a backlight issue how come when you turn the tv off you see what every channel is on for a split second?...

Chosen Solution My Panasonic Viera TC-P50U50 tv just lost image LED power light blinks 8 times…have unplugged, moved power source, no change…any suggestions? Blair Hampson, seems to be a common issue with this model. This is from Panasonic regarding the 8 blink code Symptom: Unit is dead with 8 blinks power LED. Cause: Defective SS board, part number TXNSS1SDUU. Remedy: Identify three components on the board: Q16051, D16041 and R16051. Refer to Fig....

Chosen Solution Just replaced the screen assembly on my iPhone XS. Worked fine to start, but then after about an hour it was continuously rebooting, showing 1% battery and acting very sluggish. Now it’s not turning on at all, even when put on the charger and there is a warm spot on the back near the camera (thinking it somehow shorted). Any advice? Hi Drew, Well dang, I hate it when a repair I thought went well turns out to have problems....

Chosen Solution After replacing the screen of a working iPhone 4s with broken glass, taking care to disassemble and reassemble the smartphone with the greatest attention, the device has no video, no sound and no touchscreen response. By connecting to a PC, I can note that the device “works”: the operating system starts up without problems. Watching mainboard under a microscope I noticed an unsoldered pin on the LCD connector, as shown in the video: https://www....

Chosen Solution I have a bose soundlink mini 2 that suddenly wont turn, i diagnosed it and in short the battery died. I have confirmed this that after removing (following ifixit guide) the battery i measured the voltage on the positive and negative wires and it read 0 volts, battery died. I bought a replacement (not from ifixit, although it was tagged as “original” but it could be fake) and replaced the battery as per ifixit guide....

Chosen Solution Control board (replaced 4 years ago) doesn’t light up. Unplugging and replugging the machine worked a couple of times. Now I have to trip the circuit breaker, wait a few minutes, and turn it back. Then the dryer usually works, although not necessarily on every setting. Last time, knit/low heat wouldn’t turn on, but air/no heat setting worked. After the machine started running, I turned it off and quickly pressed knit/delicate....