Chosen Solution I have a Panasonic TV model TC55CX420U and it will not turn on and there is no sound either. When I turn it on, with the remote or the TV button, the red light just comes on steady. One thing it does, back of set taken off, when I turn it on the red light turns on and in about 15 to 20 seconds I see light blink one time through the holes in the back panel, picture #2....
Chosen Solution Why is my phone charged at 100% but dies minutes later? It is a ZTE android. Tracphone It sounds like the battery in the phone is bad. If the phone works perfectly fine on the charger but dies when you take it off then battery is bad. Over time the battery will degrade with every charge and discharge. You should see about getting the battery replaced. Good luck!
Chosen Solution My S22 if left plugged in a vehicle or at the end of charging puts it into a warning that there is water in the charging port Perhaps try blowing it out with compressed air and trying again? I also recommend checking the port and cable for bent pins and if your vehicle gets warm at all while its sitting in there then that could cause problems too
Chosen Solution My iPhone was acting weird today, so I did what I usually do and shut it off for a moment, but as I was turning it back on, it shut itself off again. I’ve tried turning it on 30+ times and the result is always the same; the white screen with the black apple logo shows for a few seconds, then the screen goes black as it shuts itself off....
Chosen Solution Can I download photographs from my phone to my laptop without emailing them to myself and manually transferring them to the picture file? @treehaven51 yes you can. Here are some directions which will work for your Note regardless of provider.
Chosen Solution Hello, can some one show me a print screen of the VPP1V8_SDRAM complete line with ZXW ? I beleive I have a open circuit on that line but i don’t know where exactly Thanks PP1v8 short is usually around the Nand ic easiest way to find it is to apply direct current to that line and use freeze spray Check with multimeter first to make sure its that line that is shorted....
Chosen Solution Hello, My ps3 has one of the most odd symptoms I have ever experienced. Things to note (the ps3 did have YLOD when I purchased it) I fixed this issue and the system runs very cool. I took all the dust out of the console and dusted the board off myself. Here is the issue. Upon initial boot up the system will load a game and then go into that game’s menu, however right after loading the save file for that game(sometimes directly sometimes minutes later ) the system will crash and give the YLOD and then blinking red light(overheat)....
Chosen Solution I dropped my phone, and after that it glitched and half of my screen was covered with it. It was also unresponsive. I soon noticed that slowly where my cracks from before were turning all blue. I slept on it and by morning, It was completely black with a few glitchy looking patterns. I have no idea what to do, and scared that nothing will work!! Hi there, it seems like your LCD and digitiser assembly is broken and needs to be replaced....
Chosen Solution So my screen is sorta glitching upwards and I have no idea how to fix it. This happens randomly and goes away randomly too. Video: https://youtu.be/QTh-3ZGVUxY https://youtu.be/19C-THAd7LY Hi, Try connecting an external monitor to the laptop and check if the problem occurs on it as well. If not it may be a loose or faulty video cable between the motherboard and the LCD panel or a faulty LCD panel....
Chosen Solution My samsung tv goes on and off Check all connecting cables that are attached to your TV, such as HDMI connectors, etc. Are they all connected properly? If that doesn’t help then go into your TV settings using the remote control and choose to reset to default settings.
Chosen Solution Necesitó actualizar software a windowz 10 ya he intentado con tutoriales en youtube y nad cuando va la descarga por el 60% se corta me tira error y no se xq Google translate: I need to update it to windowz 10 I needed to update software to windowz 10 I have already tried with tutorials on youtube and nad when the download goes by 60% it cuts me error and it is not xq...
Chosen Solution Alright, so the ifixit Web host, he or she or they don’t do teardowns of EVERY model that gets posted do they? This 4 port model is my first ever Mac and I’m so glad that I didn’t know what I was missing all these years, anyways, so i’m most curious to see what the internals and everything looks like, placement etc. Am I simply missing that link for this model or?...
Chosen Solution Hi all, After replacing the taptic engine of my iphone 7, the screen does not have backlight anymore. You can slightly see the screen when you look at a certain angle. I did not remove or disassemble the screen when replacing the taptic. What could cause this problem? If you did not disconnect the battery/discharge the device after disconnecting the battery, this could have led to a short on the board that damaged your back light....
Chosen Solution My cousin has a 2015 MacBook Pro with water damage. Not much else is known about the condition. When plugged in, the MagSafe connector light turns Orange, The Force Touch trackpad is responsive and the logic board gets warm. However, nothing else happens (fan spinning, boot chime, backlight turning on, etc.) I took the logic board, fan, and MagSafe port out of the computer to inspect for water damage....
Chosen Solution I purchased a used device that wasn’t working. After restoring it seems to work fine…except it has no wifi or bluetooth. I’m assuming the chip is missing or defective. can the wifi chip be replaced? why are there so few parts for the 3G? Great News!!! The 99% alcohol isopropyl “bath” worked. Either that or it was simply the tear down that jogged something free (or back together). I just REMOVED THE BATTERY FIRST, unscrewed both the lower and upper IC boards, loosened all the ribbon cables so the lower IC board could be flipped up (not removed completely), unhooked the cable from the power/volume buttons (didn’t remove the button assembly screws at all) and then gently washed the whole works with alcohol and a soft small bristle brush....
Chosen Solution Hi, I’ve disassembled my iPhone 5 to the level where I replace the power/volume flex cable. I am now not sure what screws go in some places, even though I put each set of screws in a different place on the desk by following a video guide. Right now I need to screw the buzz/mute button bracket into place, and I don’t know which screw to use. I found a diagram with numbers for all the screws, but I have no idea how the screws look in relation to those numbers, so it wasn’t helpful....
Chosen Solution When making or recieving a call I need to activede the speaker on my Iphone othervice the I can’t hear and the reciever can’t hear me. What do I need to change? The most common source of this issue is debris in the headphone jack causing the sensor inside to continually detect headphones. This in turn forces the phone to turn off the receiver earpiece and mic. The most common source of this debris is pocket lint, BTW....
Chosen Solution My Panasonic TX-40CX400B plasma has no picture or sound. It is giving me the 8 blinks error code which I believe is for the Driver SOS 3 SS board and I can’t find any other information on this, please help Hi, Are you sure that you have the correct model number and if so that it is a plasma TV? According to this a TX-40CX400B is a LED LCD TV....
Chosen Solution Got a battery kit for iFixIt, and it seemed everything worked just fine, no problem during the swap. But when booting, now macOS panics after a while, and the Windows partition that was there too boots fine but with quite a few video artifacts. It makes me think macOS panis when switching to the graphics card but not really sure. I had a USB key with VMware ESXi on it and that one boots just fine, I don’t think it’s using the graphics drivers at all....
Chosen Solution hello, have a question how do i fix my samsungA10s which is connecting to wifi but for the past few days has been saying “connected without internet” but on the same wifi connection my other devices have no issue. Reset your network settings
