Chosen Solution Phone will work on wifi but says no network connection after screen replacement. I’ve tried taking the SIM out and putting it back in, and a reset and still nothing.. Any ideas on how I can resolve this? First, check the IMEI is present on the phone or not and also confirm that the network antenna is connected properly. Most have a wire connected to connector may loose or bad contact....
Chosen Solution wont power up, LED standby flashes 3 times as it makes a clicking noise but will not power on. I will unplug it and it just repeats the sequence, i have unplugged and held the power button for 1 minute still same sequence, i have unplugged for several hours still same sequence. Bear in mind this model does not hve power button but rather etched power symbol on clear glass edging TV frame....
Chosen Solution I’ve had !@#$ Phone for a year now and the first time when i had the problem with the power button it just would not turn off my phone, then I did some research on the web and and I came across a tip where you will take out the battery leave it like that for a day and then it will work. To my surprise it did work, for another three months and now it happened again and now I can’t turn my phone on now for a week now....
Chosen Solution Hi, One month ago I dropped my phone in pool and I took it to the service center where they have dried out the phone. Everything was working fine but later only I was able to find out that the primary microphone is not working and also sim doesn’t get detect. So couple of times I did resetting the phone pressing the volume down and power button and that fixed the SIM related issue....
Chosen Solution I replaced my ink cartage 2 times with in 5 min because the cartage will not aline its self. Have you got an idea of why it is doing this and is there an easy fix. Maybe the ink cartridges are not seated correctly or there could be still some shipping plastic that is still on them that needs to be removed. Like the plastic that covers the exit for the ink, or the plastic that covers the contacts for ink to work when they are placed in the retaining tray....
Chosen Solution My blue ray player is not opening the disk drive normally. I took it apart and found that it will open the disk drive if the metal top is removed as shown in the pictures. But if this top isn’t on it can’t read the disk. If I put in a disk while it is open then slide the top on after it seems to work fine. It will play the disks and will even open and close....
Chosen Solution I expand the memory with a module pc2700s 512mb, ddr 333mhz,during it is working, sudenly goes to freeze, an when restarting, the memory is in 512 mb.i ll tried whith 2 diferents modules, and is the same for boths.help mee. thanks. There’s a very good chance that your RAM slot is bad. Did you use different brands of RAM or RAM from different suppliers? My galaxies tab 4 keeps freezing up....
Chosen Solution Hello, everyone so my PS4 isn’t reading CDs and whenever i insert any CD (PS4 game or movie) i am having this weird sound. I tried all those things: I rebooted the PS4, rebuilded my PS4 database from safe mode, updated and restored my software, cleaned my PS4 interior and even looked into the disc drive if there isn’t something stuck or broken and if the rollers were in place too (they were and i also cleaned them with kitchen towel), i also cleaned the laser with fiber and qtips with the smallest force....
Chosen Solution I took my ps4 completely apart cleansed the entire inside the fan and heatsink and all dust inside but once I turn it on it makes a loud fan noise and then when I load a video game up it gets louder and shuts off in like 25 secs Hi Raymond, Did you separated the motherboard from the heatsink?? If yes, you should replace the thermal paste! Without it or with the “old” used thermalpaste it could overheat easily....
Chosen Solution My power port is broken where can I get a new motherboard Harry Nwobi does not look like the motherboard is available as a separate part. You can always check auction sites like eBay and see if somebody is trying to sell theirs. I suggest you disassemble your kit and take a look at the charging connector. IT should be possible to replace it with another from from places like Mouser....
Chosen Solution I pushed the reset button and the screen went off. now it will not turn back on. My RCA cambio w101 v2 tablet won’t turn on ,also it keep showing me american megatrends on the main screen when I turn it on
Chosen Solution Tab is not starting. Tried to charge many times but didnt got success. what is the reason for this and what should i do now. Update (05/01/2019) Six months back when I tried to charge my phone it was not charging. Just showing charging sign a rotating circle just like in a buffering video. Since then its not charging. I changed my charger also to find any problems if....
Chosen Solution My 2006 convertible VW beetle’s trunk is stuck closed. I can hear the trunk attempt to open followed by whirring after. The red emergency plug has fallen out before I closed it and the emergency latch won’t open it. hello , try this - fold down your rear seats, remove rear shelf, try to reach the boot handle and remove two screws holding it. then try to remove the whole panel by prying it off of the edges, be careful not to break the plastic clips holding it, then once thats off, reach and undo the latch with a hand , there is a manual release in there, then try to troubleshoot and repair with boot open, - with the latch locked whilst the “doors” are up, ....
Chosen Solution now it sounds as if pump is running and the door can not be unlocked and none of the other buttons including power will work Push “Wash Temp”, “Spin”, “Soil” three times in a row, then the panel should come to life. Then you have to wait 10 minutes for the drain cycle to run and the machine will turn itself off, which is part of the reset process....
Chosen Solution Need to bypass lid lock ge gtup270em4ww please tell me what wires to jump. And I also need to know how to reset drier as it doesnt heat any more Any time the lid is in the down position, the lid actuator presses down on lid lock mechanism which locks the door. When the washer goes into spin or rinse, the lock routine will occur. The control sends 120 VAC to control board J7 pins 2 to 6....
Chosen Solution Ok, so a little more detail into this. My Nexus 7 2012 is still going strong. It’s been locked away and unused for awhile due to being on Android 5.1.1 but I finally decided to resurrect it. I plug it into the PC, and every 2-4 seconds it connects and disconnects from the PC with a “Last usb device plugged in not recognized” error. I have tried 3 different usb cables Tried playing with MTP options Tried different usb ports Tried a cache wipe Replaced the nexus charge port Even in recovery/ADB mode it does the same thing....
Chosen Solution I have no cell network connection. It is not my provider. I took out the SIM card & put it in another phone & got cell connection. Is my phone broken? Can it be fixed? Hi! Did you check if there are any new updates for the phone? By going to settings»About phone»Update system? cellular network is not available
Chosen Solution I changed the display whilst the battery was left in and the display has stopped working. I’ve tried another display and it’s showing no backlight but an image so I think the backlight fuse has blown. But the original display shows no image, nor a backlight. How can I best diagnose the issue with the display? macOS shows the display as detected (using an external monitor to show displays connected) just no image or backlight....
Chosen Solution I’ve been charging my Alcatel 3V since 1:46 last night and its still at 0% I’ve looked up what to do but I’m not getting any answers For some reason the phone is bent too, I keep my phone in my front pocket so it shouldn’t really bend as much as it is, but I’ve also noticed that sometimes it overheats when it charges so assumed it’s something wrong with the battery or the charging port I have also noticed that I have gotten a new charger yesterday, it worked for About 30 minutes then it wouldn’t....
Chosen Solution The phone boots up, and then is immediately recognized and then not recognized. Tried to flash it back to stock but still doing the same thing. However, I need a program that will see the screen, any suggestions? Thanks! samsung makes a program called sidesync is that what your talking about, only problem with the program is that you have to have it installed on the phone and computer before it will mirror your screen
