Chosen Solution
Have serviced mixer but still not good. Its gets very hot after 3 minutes, can hardly touch motor casing( motor is out of the mixer) So far I have: Replaced capacitor Oiled both bearing felts. Note there is no choke coil across resistor. Can this cause issue??? Cleaned commutator in drill with 400grit silicon carbide. Cleaned govener contacts Used dremel to remove small amount of mica between commutator bars, they were slightly protruding. New brushes Checked commutator coil resistance Screamed at the machine several times, still no improvement. Any help on any point appreciated Love this machine Regards Eric Update (03/05/2022) This is the electrics Eric
Update (03/05/2022) I’m did not mark coil housing location when pulling apart. How can I before I have it in the correct alignment. I can see a punch mark is this meant to be used to align parts. Update (03/05/2022)
Is this an alignment mark? Update (03/06/2022)
168 and 169 trying to align Update (03/06/2022)
Are these the scribble line and punch mark Update (03/05/2022) Jayeff, Is this the scrib line and punch mark I need to align. Regards, Eric
Hi @phantomwalker , Here’s the service manual for the mixer. On p.8 it describes the re-assembly of the motor. Hopefully this is of some help.
