Chosen Solution
I make this topic so other with the same problem, can find the solution here. iPhone 5 not searching for network. Only says No service. I had this problem when i changed powerflex on iphone 5. The screwdriver slipped and it then wouldnt find signal. I found out this was missing:
After soldering this it had fine signal again.
ive located the component, its a 70-OHM-300MA resister. it is part of the phones RF TRANSCEIVER DECOUPLING.
Hi after seeing your post i try to identify if my problem is the same . Can you explain if there is a components at the place you solder ? Mine looks like none. But before solder i just want to make sure. So you make a bridge between the two solder point ? thanks
The one i fixed had broke the resistor clean off, so i just soldered between the 2 points. Try to get a magnifier to see closely if it is missing.
Hi thanks for your answer. I take a magnifier and see a gap between two pin next to the screw hole. is this correct or is this the resistor behind this two pin ? I will try to take a photo but it’s not easy… Thanks a lot..
To illustrate see the image. This is the 1 or the 2 ? Thanks
It is the one closest to the screw hole. So it is number 1.
I try but it’s very difficult to sold…
Did but nothing change… Thanks again for your advice. I appreciate. Hope your solution work for another. Have a good day /night
