Chosen Solution
Need to replace 4- pole Jack plug cut off old plug & the existing cable colours are Red Blue Green & copper Can you tell me which cable goes where on the new jack please.
I have a final answer to this issue. This for the Turtle Beach PX-22 Headset with a broken plug. The plug is inserted into the Amplifier which in turn plugs into a PC via a USB connector. The plug needs to be low profile or narrow as it wont fit into the amplifier otherwise. The following cable wire colour to 4 pole plug as follows: Green - tip; Red - ring 1; White - ring 2; Blue and copper twisted and soldered to - sleeve/ring 3. I am pleased to say this works perfectly. Additionally, I bought a new cable - 4 pole plug to 4 pole plug. Cut it in half and connected the wires based on ‘buzzing through’ to the plug with my multi-meter as the internal wire colours in the replacement cable were different colours to the turtle beach internal wires. It was much less bother than using a brand new ‘blank’ narrow profile 4 pole plug (too much of a challenge to my soldering skills and eyesight!). I hope this helps for anyone with the same or similar issues.
I fixed it with: Old jack was wired like: tip (ring 1),ring 2,ring3,ring4 green,red,blue + ground (copper),white It seems different than above. I cut the old jack first and measured resistance through the wires.
I have the same problem and i did not find a new 4 pole cable with 5 wire. I solder a new 4 pole cable with 4 wire. It work but mic doesnt work….if anyone can find a 5 wire cable on ebay for exemple !!!
